Installation

Tuby Pool Assembly Instructions

(Optional) Place the insulating mat underneath the pool.

1. Place the pool on a flat surface and make sure it is stable.
2. Prepare the drain valve (black valve): unscrew it, place the rubber part inside the pool, then screw the outer cap on from the outside. Remove the protective foil from the product.
3. Make sure the edge of the rubber seal faces inward (see video) at the lowest opening.
4. Attach the white heating connector to the pool (it has two O-rings and comes with cover caps).
5. Connect it through the upper/middle opening of the pool (the two upper openings are the same size).
6. Place one O-ring on each side of the pool wall at the connector opening.
7. Screw the cover caps on from the outside.
8. The open pipe of the connector should remain visible from the outside.
9. Prepare the filter pump: remove it from the box, place it next to the pool, and connect the hoses according to the filter manual.
10. You may use either the original hoses from the filter package or the shorter blue hoses provided by TubyPool.
11. Connect the lower hose to the upper outlet of the filter, and the upper hose to the lower outlet of the filter.
12. HEATING: if you would also like to connect the heater, remove the lower hose from the filter and use an additional hose supplied with the heater to connect the heater and the filter. Pay attention to the arrow on the heater, which indicates the direction of water flow: the connection from the filter goes into the right side, while the hose leading back to the pool connects on the left side.
13. The pool is now ready to use: fill it with water to approximately 10 cm below the top edge, switch on the equipment, and allow the water to heat up.
14. After use, it is recommended to cover the pool with a properly sized cover, which can be purchased separately.

If you experience any issues, please contact us at sales@tubypool.com.